| Loading the Monarch 1110 labels into a Monarch 1110 is | | | | the label strip up under the black plastic plate in the |
| aprocess that may seem complex, but only takes a | | | | front of the gun. The labels should start to come out |
| few steps complete and a few times to master. | | | | the top of the gun by the application roller. |
| Follow this Monarch 1110 instructions guide and you'll be | | | | Once you have two labels coming out, squeeze the |
| back in business in no time. I would like to say that all | | | | hand trigger half way again and rewind the roll of |
| new Monarch 1110 guns from reputable dealers do | | | | labels so the loop of labels is removed in the front of |
| come with loading instructions included in the box. If you | | | | the gun and the labels are tightened up. Then grasp |
| have just purchased an Monarch 1110 gun and | | | | the two labels in the front of the gun and quickly pull |
| instructions were not included with it, you may want to | | | | the strip downward toward the hand trigger. This |
| call the seller and ask why. All the Monarch 1110 guns | | | | process will remove the labels from the backing paper. |
| we sell at B&B Supply have easy to follow | | | | You will want to have about seven inches of just the |
| loading instructions included. | | | | backing paper now. Hold the Monarch price gun upside |
| Start by first tearing off the first 12 or so labels from | | | | down and squeeze the hand trigger all the way |
| the label roll. This will insure that the adhesive used to | | | | exposing the feedwheel. Feed the backing paper into |
| hold the first label to the roll will not get exposed to the | | | | the slot with the arrow until you feel tension from the |
| inner workings of the gun. The adhesive could lead to | | | | feedwheel. Start squeezing the hand trigger several |
| a label jam in the future. Then snap the roll of Monarch | | | | times to tighten up the paper. If the wheel does not |
| 1110 labels into the back of the gun between the hubs. | | | | grab the backing paper right away, keep feeding it into |
| You want the labels to come off the top of the roll. | | | | it. Turn the gun right side up after the backing paper |
| Next pull and hold the hand trigger about half way. | | | | first grabs. After about six or seven clicks, printed |
| Pulling the hand trigger disengages the brake wheel | | | | labels should start coming out the front of the gun. Try |
| and allows you to slide the label strip through the gun. | | | | to always make sure that only backing empty backing |
| Insert the label strip into the gun by basically following | | | | paper (with no labels) travels down the gun and gets |
| the plastic avenue you see. The Monarch 1110 labels | | | | grabbed by the feedwheel and goes out the back of |
| should start to come out the front of the gun. Continue | | | | the gun. Jamming could result if labels are pulled |
| feeding until you have about eight inches hanging out | | | | through the feedwheel. |
| of the front and release the hand trigger. Next, feed | | | | |